Colors and Threads
Thread Estimates
StitchALot Studio estimates how much of each thread your design needs, so you know how much floss to buy.
Where Estimates Appear
- In the Palette panel — Select a color and the details below the palette show its estimate on up to three lines: skeins, yards with your waste allowance, and the exact yards (for example, "1 skein / 5.5 yd with 20% / 4.52 yd exact")
- On the PDF chart — The Color and Symbol Legend shows each thread's estimate (for example, "1 skein · 6 strands · 3.00 yd exact · 3.6 yd plus 20%"), with a total at the end of the legend, so the legend works as a kit pull sheet
An estimate appears for colors that have stitches or backstitch on visible layers.
Setting Up Estimates
Estimates are set in File > Export > PDF, and the same settings are used in the Palette panel:
| Setting | Options |
|---|---|
| Include thread estimates (strands, yards, skeins) | Untick to leave estimates off the PDF |
| Stitch | Tent stitch (basketweave) (default), Tent stitch (continental), or Cross stitch |
| Allowance | Plus 0%, 10%, 20% (default), or 30% for tails and waste |
How Estimates Are Worked Out
- Stitches — Each stitch uses thread on the front of the canvas plus the path behind it. Continental uses more thread than basketweave, and cross stitch more again. Half and quarter stitches use a share of a full stitch
- Backstitch — Measured from the length of your backstitch lines
- French knots — A fixed amount per knot
- Strands — A color uses the strand count from an imported chart's key when there is one. Otherwise, a suggested count for your mesh is used:
| Mesh | Tent stitch strands | Cross stitch strands |
|---|---|---|
| 10 and under | 12 | 3 |
| 12–13 | 10 | 2 |
| 14 | 9 | 2 |
| 16 | 8 | 2 |
| 18 | 6 | 1 |
| 22 | 4 | 1 |
| 24 | 3 | 1 |
- Skeins — Counted from the yardage with your allowance, based on 8.7-yard skeins of 6-strand floss, and rounded up for each color
- Kreinik — Shown in yards only, since spool lengths vary
Estimates are a guide — your own tension and how you start and end threads will make a difference. Raise the allowance if you tend to run short.